The BS-25 heat shrink sleeve with a diameter of 2.5 mm in white was created for printing in marker printers. The T-shirt has a round cross-section and is designed to mark wires with a diameter of 0.24 - 0.75 mm2
BS heat shrink tubes are especially recommended when you need to ensure that the profile is well attached to the cable. The marking of cables made using a heat shrink sleeve adheres perfectly and there is no risk of its displacement. The shrinkage ratio of the tube is 2:1 - the tube can therefore shrink up to half of its original diameter.
For marker printers:S700E, K900, TP80E, TP76E, M1 PRO IV, M1 PRO V, M-1STD, MK8, T-800
Printing on the BS heat shrink tube in marker printers requires a dyeing tape suitable for the printer model:
M1-PRO IV, M1-PRO V printers - BP-100C ribbon
TP80E, TP76E printers - ribbon TP-R100EB
S700E printer - RS-80B ribbon
K900 printer - ribbon - RS-80BC
No customer reviews for the moment.
Your review appreciation cannot be sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Your comment has been submitted and will be available once approved by a moderator.